Our structural hardware is BRANZ Appraised against NZS 3604, our 90 × 3.15 mm bright framing nail holds a BRANZ Standards Test report, and our entire manufacturing line operates under an ISO 9001 certified quality management system.
Our Joist Hangers and CPCs hold full BRANZ Appraisal Certificates — the highest tier of product certification in New Zealand for structural building products.
Alternative connection of curtail joist to trimmer, or trimmer to trimming joist, as described in NZS 3604, for timber-framed structures. Galvanised, four sizes.
Alternative connection in roof construction to tie a pair of rafters to the ridge board, and rafter-to-top-plate connection, as described in NZS 3604. Galvanised, two sizes.
BRANZ Standards Test report ST1224 #101 covering the 90×3.15 mm bright framing nail — used in NZ light timber-framed construction (NZS 3604). Test report on file at our Auckland office.
Our fastener manufacturing line operates under ISO 9001 certified quality management — from raw wire inspection through galvanising to packaging. Every Kiwi Nails product is made under documented QMS procedures.
Every Kiwi Nails pack carries a unique GS1-NZ-registered EAN-13 barcode, scan-compatible with every NZ point-of-sale system used by merchants.
All product packs carry a unique GS1-NZ-registered EAN-13 barcode (prefix 9420052) — scan-compatible with every NZ point-of-sale system used by merchants. The complete GTIN list for current Kiwi Nails SKUs is available on request.
Quality management system certification covering our manufacturing line.
Light timber-framed buildings — our CPCs & Joist Hangers are BRANZ-Appraised under this standard.
Hot-dip galvanised coatings on iron and steel articles.
Welding & structural steelwork compliance for hardware brackets.
Hot-rolled structural-steel bars, sections and chemistry.
External moisture — durability zones for fastener material selection.